6mm-13mm Staplers Air Stapler Gun Air Nailer Air Tool Hand Tools


  • $24.43

  • Ex Tax: $24.43
  • Availability:In Stock
  • Product Code: 778956



Specification:
Dimension 45X145X210 mm
Weight 2.86kg
Power Source Pneumatic
Required pressure 70-110PSI(4.8-7.5bar)
Max.Pressure 120PSI (8.3bar)
Capacity 100000
Feature:
Upholstery Stapler.
Uses: 1/4'' to 1/2'' 20-gauge staple;
Comfortable rubber soft grip;
Accepts 1013J Series Staples.

Air Nailer Trouble Shooting: 

Symptom      Problem               Solutions    
Air nailer's leak near top of tool or in trigger area

1.O-ring in trigger valve are damage

2. Air nailer's trigger valve head are damage

3.Air nailer's trigger valve stem, seal or O-ring are damaged

1.Check and replace O-ring

2.Check and replace

3.Check and replace trigger valve stem, seal or O-ring

Air Nailer's leak near bottom of tool

1.Loose screws

2.Worn or damaged O-ring or bumper

1.Tighten screws

2.Check and replace O-ring bumper

Air leak between body and cylinder cap

1.Loose screws

2.Worn or damaged O-ring or bumper

1.Replace bumper

2.Adjust the air pressure

Blade driving fastener too deep

1.Worn bumper

2.Air nailer pressure is too high

1.Verify adequate air supply

2.Place 2 or 6 drops of oil into inlet

3.Check and replace O-ring or seal

4.Replace damaged air nailer internl parts

Air nailer does not operate well: can not drive fastener or operate slugishly

1.Inadequate air supply

2.Inadequate lubrication

3.Worn or damaged air nailer's O-ring or seals

4.Exhaust port in cylinder head is blocked

1.Verify adequate air supply

2.Place 2 or 6 drops of oil into air nailer's inlet

3.Check and replace O-ring or seal

4.Replace damaged internl parts

Tool skips fasteners

1.Worn bumper or damaged spring

2.Dirt in front plate of the air nailer

3.Dirt or damage prevent fasteners from moveing freely in  spray gun's magazine

4.Worn or dry air nailer's O-ring on piston or lack of lubrication

5.Cylinder cover air nailer's seal leaking

 

1.Repalce bumper or pusher spring

2.Clean drive channel on front plate

3.Air nailer's magazine needs to be cleaned

4.O-ring need to be replaced and lubricate

5.Replace sealing washer

Tool jams

1.Incorrect or damaged fasteners

2.Damaged or worm driver guide

3.Air nailer's magazine or nose screw loose

4.Air nailer's magazine is dirty

1.Change and use correct fastener

2.Check and replace the driver

3.Tighten the magazine

4.Clean the magazine

Package included:
1XAir Staple Gun






 

There are no reviews for this product.

Write a review

Write a review

Note: HTML is not translated!
    Bad           Good
Captcha

demo en